Blog Archives

Pocket Wizard TT5 Repair

I take my Pocket Wizard gear everywhere I go for shooting.  It’s invaluable for lighting and provides awesome flexibility for my flash to fire off remotely.   I first learned about them thru friend photographer Tommy Pemberton.  Check out this stuff at http://www.tomeemot.com/.

Like him I was originally was using it on a Canon 580EX II.  I replaced it with a lesser expensive flash 430EX II after both were stolen from me by some burglar.  While there  are a number of differences with the flashes I found them to be close enough for my sustaining my hobby.   I recommend reading Photo Tips Online.com for their side by side comparisons.  http://photo-tips-online.com/review/canon-430ex-ii-vs-canon-580ex-ii/nutshell/

So first of all the problem with the TT5 that you will find around the ‘net is some radio interference issues which can be simply fixed with a shield that wraps around the unit. Outside of that you’ll rarely see any posts on the effects of mounting the flash over and over which eventually causes the hot shoe to detach at a 45 degree angle.  I am sure a few stressed pack ups w/o removing the flash to get to the next site did it as well. Unfortunately you have to take apart the whole unit because the screws mount from the inside.  I can’t afford any more TT5s so this is one I thought I would fix myself.

Here are the pics from the repair. Notice the picture where the screws just lying within the unit, they weren’t even stripped which is what I thought I was going to find.   I hope they fix this in the future so that this doesn’t happen again.

This is how i found the screws, they barely catch!

 

TT5 sensors

 

Springs have to be carefully put back

 

TT5 Mother board

TT5 base, you see the antenna here in the corner